6-in-1 POWER PACK Owners Manual
Page 11
061410
8&%,"-,$@%,;0<5=,;>/?
,
/01231456
If cables are attached to the incorrect battery terminal the
Cables Reversed LED will switch on and a warning tone will
sound. If this occurs, correct the connection before
proceeding to the next step. Failure to do so may cause
sparking, personal injury and/or harm to the vehicle or
jumpstart unit.
Check to be sure that the cables are clear
of all moving engine parts.
9. Turn the jumper cables power switch to the “ON” position
(see Figure 1 on page 5 for location A). Crank the engine.
Do not crank for more than six seconds. Allow the Power Pack
to cool for at least 3 minutes between six second jumpstart cycles.
10. After successfully starting the engine, turn the jumper cables power
switch back to the “OFF” position.
11. Remove the black negative (-) clamp and return to its stored position.
12. Remove the red positive (+) clamp from the battery and return to its
stored position.
Using the integrated work lamp
To use the integrated work lamp, simply press the work lamp power button
located directly above the work lamp (see Figure 2 on page 5 for location J).
Using the compressor
The air compressor in the Power Pack is designed as a convenient portable
inflation device. After ten minutes of continuous use, turn off the compressor
and allow it to cool for ten minutes. Continue use, if necessary, following this
ten minutes on / ten minutes off cycle (see Figure 1 on page 5 for location I).
Allowing the compressor to run in excess of 10 minutes can
result in permanent damage to the compressor, jump start
unit, property or personal injury. Make sure the compressor
ventilation slots are free of debris and air can circulate around
the compressor motor while in use.
Inflating a tire or object using the compressor
1. Secure the inflator nozzle to the valve stem using the thumb latch.
2. Switch on the compressor via the switch on the front of the Power Pack
(see Figure 1 on page 5 for location D).
3. Check the pressure gauge on the front of the Power Pack, once desired
PSI is reached remove the valve connector by releasing the thumb latch.
4. Turn off compressor via the switch on the front of the Power Pack .
WARNING
WARNING
