Chapter3 Softwar
e & config
Manual of NCH02
- 19 -
as MPG). Under the ready state of system, push
3 modes can be switched.
2. Running status bar
The status bar mainly displays the working state of the system. There are four systems in it.
They are reset state (shown as RESET), ready state (shown as READY), manual control state
(shown as JOG) and running state (shown as RUN). In reset state, all operations are invalid, it's
the system protection state; the ready state is ready for work. Any operation can be performed in
the state of preparation; By pressing
, the system can be switched between the ready
state (READY) and the reset state (RESET). In the ready state, when the G code is ready, the G
code can be started by pressing
, or the start line of the G code can be specified by
pressing
+
. In the process of running G code, the running status bar displays the
RUN, indicating that the G code is running. During the operation of hand control operation, the
running status bar shows JOG, indicating that hand control is working.
3. File status bar
The status bar displays the file loading G code or U disk information, It displays "No file
loaded" in the file without loading condition; it displays "U-Disk Detected" when the U disk
insert and correct recognition; "U-Disk Removed" display in the U disk pulled out; it display G
code file name when loaded the correct G code;
4, time display bar
The time display bar mainly displays the current G code running time.
www.nvcnc.net
