NVIP-3DN3630SD/IRH-2 User’s manual (short form) ver.1.0
All rights reserved © AAT Holding S.A
17
2. Video Parameter
Stream
- Stream ID (choose one from available streams)
Bite Rate Type
- Information about bit rate type
Bit Rate (kbps)
- Information about bit rate
I Frame Interval
- Information about I frame interval
Quality
- Information about quality
USE TIME STAMP - Video buffer (increases delay when enabled, maximum delay is 5s)
NOTICE:
USE TIME STAMP
function will not be available when using Flash instead of ActiveX.
3. PTZ Control Panel
PTZ Configure:
Preset
- Programming, deleting, and recalling presets
Track
- Programming, deleting, and recalling tracks
Speed
- Setting speed of movement
3D Position
- Turns on/off control using the mouse
North
- Setting orientation of the camera
Timer
- Setting schedules
PTZ Control:
Arrow keys
- Controlling the movement of the camera: up/down, right/left
„Home” key
- Function unavailable
Zoom
- Zoom control
Focus
- Focus control
Iris
- Function unavailable
Brush
- Function unavailable
On/Off IR
-
Function unavailable
4. Menu bar
Change Password
- Change users password
NOTICE: Default password "pass" can be restored only after restoring default settings of the camera)
Sign Out
- Log out from camera
5. Video Control
Camera
- Default number of the camera is 1.
Video
- Turn on/off video
Audio
- Turn on/off audio
ELECTRIC CONNECTORS AND ACCESORIES
5. ELECTRIC CONNECTORS AND ACCESORIES
5.1. Connecting power supply to the camera.
The camera should be powered by an external power supply included in the
set. If the power supply is changed, the new power supply should not be lower
than 65W.
CAUTION!
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
5.2. Connecting Alarm Input/Output
Alarm input:
There are seven independent alarm input ports (ALM-IN1~ALM-IN7) and one common port (ALM-IN
-COM).
connect DC5V~DC12V voltage between the alarm input port ALM-Inx (x=1~7) and the common port
(ALM-IN-COM).
Disconnect the voltage between alarm input port (ALM-Inx (x=1~7) and common port (ALM-IN-OM)
to cancel the alarm.
Alarm output:
Support 1CH alarm output including OUT1+, OUT1- connections; support two input modes namely
NO, NC.
Alarm output: One passive switch for user to connect alarm devices; the alarm output state will be auto
on/off according to your setting.
5.3 Audio Input/Output
The camera has two connectors audio jack, to connect an external speaker or microphone (MIC/LIN).
MICROPHONE
POWER SUPPLY
