NVIP
-
2V
-
6502M/F Quick start guide version 1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
11
CAUTION!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop
-
through ones, seal them too.
2.5 Starting the camera
To run the camera you have to connect ethernet cable between cameras RJ45 socket and network
switch PoE compatible with IEEE 802.3af standard. To power it up you can also connect it directly via
power supply adapter with parameters compatible with camera power supply specification.
The recommended way to start an IP camera and perform its configuration is a connection directly
to
the network switch which is not connected to other devices. If camera is powered by an external
power supply, use any switch or twisted
-
pair cable connected directly to your computer. To obtain
further information about network configuration parameters (IP address, gateway, network mask, etc.)
please contact your network administrator.
The following pages of this manual show 3 recommended connection schemes for the camera:
•
Connection using the PoE network switch.
•
Connection using external power supply to the camera and network switch.
•
Connection using external power supply to the camera and Ethernet cable.
Connection using the PoE network switch.
START
-
UP AND INITIAL CONFIGURATION
Computer
Power supply and network
transmission
Network transmission
IP Camera
Network PoE switch
