NVIP-2DN6020SD-2P User’s manual (short form) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
12
•
Remove the bubble by pulling down the side on which the locking pin is not placed.
•
Remove the camera module protective elements in the form of tapes, sponge and lens cap.
•
Mount the camera bubble by pressing in a manner analogous to the dismantling and
unscrewing of blocking screws 1 and 2 (unscrew the screws until you feel light resistance) and
screwing the screw 3. In order to more easily pressing the bubble grease the bubble rubber
with use the lubricant in set included.
START-UP AND INITIAL CAMERA CONFIGURATION
M3 screw - Phillips or
Torx with two washers.
1
2
3
