All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
9
NVIP
-
2ATM
-
6501/F
Quick start guide
version 1.0
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
9
START
-
UP AND INITIAL IP CAMERA CONFIGURATION
2.3. Ethernet cable connecting
To maintain tightness of ethernet cable connection, please follow instruction below:
1. Unscrew the nut (
1
) from the connector cover (
2
).
2. Route the network cable (without the RJ
-
45 plug) through the components (
1
) and (
2
), than crimp the
RJ
-
45 connector.
3. Plug the RJ
-
45 connector into the hermetic socket (
3
), screw the connector cover (
2
), and than the
nut (
1
).
NOTICE!
The camera housing is not hermetically sealed. Do not install the camera outdoors or in places
exposed to moisture.
2.4. Camera mounting
1. Remove the camera holder by unscrewing both fixing screws on the sides of the camera, indicated by
red arrows.
2. Mount the camera holder in the selected place with a suitable screw or bolt.
3. Place the camera between the fork of the holder and mount it with fixing screws, screwing them in so
that you can adjust it.
4. Adjust the camera position and tighten with the fixing screws
To set the preview from the camera, connect the power to the camera and then connect
with the camera using a PC.
1
2
3
1
2
