NVIP
-
12F
-
8001, User
’
s manual (short) ver.1.0
All rights reserved © AAT Holding S.A.
11
2.3. Connecting Ethernet cable
To maintain tightness of Ethernet cable connection, please follow instruction below:
1. Loosen the nut (a) from the main element (b).
2. Run power cable (without RJ
-
45 connector) though both elements. Then crimp the cable with RJ
-
45
connector. Install rubber gasket (d) on the connector (c).
3. Connect the cable to the waterproof connector (c), screw main cover (b), then screw the nut (a).
Caution: The other camera connectors are not waterproof. User should seal them by himself.
Caution:
It is forbidden to use –
as the camera power source –
PoE equipment (adapters, etc.) not
compatible with IEEE 802.3af standard (items called
“
passive PoE power supply
”).
Damages that
results from the usage of improper power supply source are not covered by the warranty.
a
b
a
b
c
d
START
-
UP AND INITIAL CAMERA CONFIGURATION
