NVC-DN6127SD-II and NVC-DN6137SD-II User’s manual, ver. 1.0
All rights reserved © AAT Holding sp. z o.o.
17
•
Connect required signal and power supply cables.
•
Put the excess cable back into the bracket.
•
Put the dome onto the bracket so the vertical markings on the dome and bracket’s surface are
aligned and turn right until resistance is felt.
•
Screw the camera to the bracket using three Torx screws (key included). Please make sure that
the casing fits the bracket after screwing, otherwise the rubber gasket won’t fill its purpose
and water may get inside the camera.
•
Remove the lens plug from the camera module.
•
Attach camera bubble to the casing paying special attention to rubber gasket. Please make
sure that the gasket fits the gap between bubble and casing, otherwise water may get inside
the camera.
CAUTION!
The supply voltage should be turned on when camera unit is completely installed. Otherwise,
enter camera’s menu and reboot it after finishing installation.
MOUNTING THE CAMERA
