NVAHD-2DN5504MV/IR-1 - User’s manual ver. 1.0
All rights reserved © AAT Holding S.A.
7
INSTALLATION
3. INSTALLATION
3.1. Power supply connection
WARNING: Device should be supplied only from a power sources whose parameters are in
accordance with those specified by producer in the camera’s technical datasheet. Therefore, it is
forbidden to supply the camera from power sources whose parameters are unknown, unstable
or not meeting the producer’s requirements.
3.2. Camera mounting
To mount a camera please follow the instructions below:
1.
Unscrew the retaining ring from the base, remove the camera module
2.
Taking the bracket’s base screw holes as a pattern, mark future drilling holes for screws.
3.
Drill holes in accordance with previously done markings and base hole placement.
4.
Mount the camera using the supplied plugs and screws.
5.
Connect the camera cables and pre-tighten the retaining ring.
6.
Adjust the position of the camera module and lock it firmly by tightening the retaining ring
7.
After connecting the camera to the AHD Novus recorder, adjust the zoom and focus (if
necessary).
WARNING!
Please note that the wall or ceiling must have enough strength to support the Camera.
WARNING!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
WARNING!
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs.
video
12V DC +/- 10% power supply
video
(GND)
+
- (GND)
