Chapter 4 RELAY7 Troubleshooting
RELAY7 User Manual v3
30
If the TIMEOUT issue is resolved, enter the SMART7 user settings that were erased by the
FRESET
command.
For information about the commands and logs used in this procedure, refer to the
Commands and Logs Reference Manual
.
4.5 SATELSTATUS Log Reports COMMAND FAILED
The
SATELSTATUS
log reports COMMAND_FAILED if the SMART7 was unable to configure the
radio settings.
4.5.1 Unexpected radio response
If the radio module malfunctions, the radio may not respond to the commands issued by the
SMART7 in the expected manner. If this happens, the command that was issued will be included
in the
SATELSTATUS
error message. Some examples are:
<SATELSTATUS COM1 0 80.0 FINESTEERING 2009 317886.722 02000000 aaba 32768
< ERROR COMMAND_FAILED "SL~E=M1,I23,A99"
<SATELSTATUS COM1 0 79.3 FINESTEERING 2009 317889.543 02000000 aaba 32768
< ERROR COMMAND_FAILED "SL@S=99"
To recover from this type of error:
1. Use the
SATELCONTROL
command to return the radio module to a known state.
SATELCONTROL FRESET
2. Wait for the
SATELSTATUS
log to transition to BUSY and then to READY.
<SATELSTATUS COM1 0 73.0 FINESTEERING 2009 317587.963 02000000 aaba
32768
< BUSY NONE ""
<SATELSTATUS COM1 0 80.0 FINESTEERING 2009 317598.053 02000000 aaba
32768
< READY NONE ""
3. Configure the radio to the desired settings.
4. Wait for the
SATELSTATUS
log to transition to BUSY and then to READY.
<SATELSTATUS COM1 0 76.5 FINESTEERING 2009 321491.063 02040000 aaba
32768
< BUSY NONE ""
<SATELSTATUS COM1 0 77.5 FINESTEERING 2009 321496.684 02040000 aaba
32768
< READY NONE ""
4.5.2 Wrong Command for Radio Type
If the wrong type radio configuration command (SATEL4CONFIG, SATEL9CONFIG,
SATEL9CONFIGL or SATEL9CONFIGN) has been issued to the radio module, the SMART7 will not
attempt the configuration. This error will be shown in the
SATELSTATUS
log. For example:
SATEL9CONFIGL P2MP_RX_SLAVE 4 10 FF FALSE 0 0
<OK
<SATELSTATUS COM1 0 80.0 FINESTEERING 2009 317886.722 02000000 aaba 32768
