14
PIT WIZARD INSTRUCTION MANUAL
PRECAUTIONS
In addition to using basic common sense, please take special note
of the following precautions:
• Water and electronics DO NOT mix.
• DO NOT allow solvents to come in contact with the Pit Wizard
to avoid damage to the case and electronics.
• DO NOT allow connector pins on D•LINK harness to contact
transistor tabs or heat sinks on speed control.
• DO NOT touch connector pins on D•LINK harness to avoid
static electricity damage to the electronics.
• Be careful when connecting or disconnecting D•LINK harness
to DataLink socket on speed control to avoid damage.
ACQUIRING DEFAULT PARAMETERS
In order to edit and customize Profiles, you must first upload the
default parameter values from your Cyclone speed control. When
you upload the default parameters you will be reading Profile 1,
2, or 3 from your Cyclone (The Profile that is currently active).
Neutral, Full Throttle, and Full Brake are the default parameters
that were programmed into the Cyclone’s One-Touch memory,
based on the available throw of your transmitter. These values are
the standards for what will be the newly created Profile 4.
In most cases, you will not want to modify the values for Neutral,
Full Throttle, and Full Brake.
These values set the exact point of
Neutral, and give you the complete range of throttle in both the
forward and brake directions. However, there are some instances
that will be discussed later in the Editing Parameters section, in
which changing these values could be useful.
Note: Before creating custom Profiles, it is important to check the
available throw of your transmitter by following the steps in the
Monitoring Transmitter Trigger section (next page). If there is not
sufficient throw you will need to change your transmitter’s set-up.
