25
Then lead the pull-up cord through the
sliding clip app. between cross rib #3
and #4. Tighten it and make a knot.
By pushing or pulling the clip you can lift
or lower the rudder.
Your
nortik navigator
is now fully assembled with rudder system.
Have fun on the water!
Instructions for disassembling:
-
For the
disassembling proceed in the same way as for assembling but in reverse
order.
-
For the disassembling it is
absolutely necessary to take out cross rib #3
.
-
Open the hatches and slip them outward, so that the rods won't get caught up in it.
-
Should it be a little hard - especially in the beginning - to pull out the frame from the
hull, tap with your flat hand on the front of the lower part against the bow. Here, the
boat should lay flat and the stern should already be taken out of the skin. Especially
the first 2-3 times, it may be that the bow frame sits very tight in the skin. By tapping
the frame should slightly loose itself from the skin and it then gets easier to pull out.
You can also grab through the front hatch and slightly loosen the frame.
Folding the hull
Before folding the skin, spread it out
flatly,
push the cockpit to one side and fold in
the other side.
Then you start with the tips and fold
them in from each side.
Proceed as shown in the pictures…
