7
07228A-2
OWNER’S MANUAL
# 52905
ver.
07228A-2
Page:
7 ENGLISH VERSION
NOTE:
If you do not have modular
telephone jacks or experience any
difficulties in connecting the telephone,
contact your telephone equipment dealer
or an experienced telephone wiring
technician for assistance.
Single Cord Connection
1. Connect the handset cord into the
handset and into the side of the base
unit.
2. Insert the 4-conductor telephone
line cord into the LINE 1 + 2 jack
on the rear of the base unit.
3. Insert the opposite end of the
4-conductor telephone line cord into
the modular wall jack.
Wall Use
(with a standard AT&T or GTE modular
wall jack)
1. Connect the telephone line cord to
either one of the line jacks on the
rear of the base unit.
2. Route the short line cord into the
groove on the back of the base unit.
3. With the rear of the base unit facing
up, insert the flange of the wall
mounting bracket into the bottom
slot on the back of the unit and plug
the free end of the short telephone
line cord into the wall modular jack.
4. Mount the base unit to the modular
wall jack by hooking the stands on
the wall plate into the keyholder
slots on the back of the base unit as
shown in figure 2.
NOTE:
If your phone lines come into
separate jacks or if you do not have a
standard wall jack, contact a telephone
service technician to mount one on the
wall.
Handset Retainer Tab Installation
If the base unit is to be placed in the wall
mount position, the handset retainer tab
must be pulled out, turned around and
placed in the opposite direction, so that
the tab allows the handset to hang onto
the base unit.
NOTE
: Please refer to the EasyTouch
52905 Controls Diagram for the location
of the Handset Retainer Tab.
RINGER OFF / ON Switch
Move the switch to the HIGH or LOW
position to enable the ringer function.
Switch it to OFF to disable the ringer
function.
TELEPHONE OPERATION
PULSE / TONE Dialing
1. If you have tone dialing service, set
the PULSE / TONE switch to TONE
position.
2. If you have rotary dialing service,
set the PULSE / TONE switch to
PULSE position.
NOTE
: The pound (#) and star (*) are
not dialed out during PULSE mode.
Mixed Mode Dialing (P -> T Tone
Dialing)
If you only have a pulse (rotary) dialing
service in your area and want to access
Tone dialing services, set the PULSE /
TONE switch to the PULSE position.
Before dialing out the phone number
upon picking up the handset, press the
base unit Tone ( * ) button once. You
can then access tone dialing services
when using a pulse dialing system.
(Figure 2)
