1200 Series Display, Rev. A2
What’s in this Manual — Page 3
What’s in this Manual
This manual is in three basic parts. The first part consists of
information related to getting started as well as basic informa-
tion about the display.
The second part of the manual, beginning on page 22, addresses
the installation process. Typically only the installer will use this
section. However, it does provide ideas and pointers for locating
your display as well a list of installation tips.
Finally, the third section, beginning on page 38, describes how to
troubleshoot the display and how to get service should the need
arise.
Getting Started
Turning the Display On
To turn the display on, simply press
until the display
lights up. Within a few seconds, you will see a picture if an
active source is plugged into either the Data or Video
connector on the back panel.
Adjusting the Brightness
The brightness control is located on the right hand side of
the display. Press the up arrow to make the screen brighter
and the down arrow to make the screen dimmer.
The DATA and VIDEO Buttons
These two buttons control what image is displayed on the
screen. Simply press the button corresponding to the image
you wish to view.
Press
to see what you’ve connected to the VGA Data
connector on the back of the display. Press
to display
PWR
DATA
VIDEO
