6
Drill 3 holes each side equal distance apart
in vertical section of aluminum frame and
install screws as shown.
Wood Shim
7/8" x 1" x 68"
7/8"
1"
G
F
E
D
✷
Install Wood Shim to
one of the Cabinets
before installing in
rough-in cavity.
✷
After properly installing
both Cabinets, drill trim
and install pan head
screws (provided).
When two units are installed together, a
23
1
⁄
2
" x 12"(min.) divider panel needs to be
installed between the two modules (refer to
illustration) with self-tapping screws. The divider
panel can be made of any material available
i.e.
1
⁄
32
" aluminum,
1
⁄
8
"-
1
⁄
4
" wood paneling).
Locate the divider panel approximately 1" down
from top of cabinet and flush with back of
cabinet. Drill three pilot holes approximately
1
⁄
2
"
up from bottom of divider panel, through panel,
and into cabinet. Secure panel to cabinet with
three screws using pilot holes previously drilled.
INSTALLING TWO UNITS SIDE-BY-SIDE
KICKPLATE INSTALLATION
Two clips are supplied to facilitate holding your kick plate (not supplied) in place. Simply
position and attach these clips to the rear of the kick plate so they snap on to the leveling legs,
for easier access or removal. (Notching of upper corners may be required to clear hinges).