background image

3625 Cincinna

ti

 Avenue, Rocklin CA 95765 

● 855

-3

88

-7422 

● 

[email protected]   

   

PANEL DESCRIPTIONS:

 

 

1. DC56V IN: Power Supply DC56V/65W (Included). 
2. PoE: Ethernet Interface (10/100Mbps for full duplexer), for PoE Output to camera 
3. ACT./LINK: Data Link for indica

ti

on LED 

4. POWER: Power On for indica

ti

on LED 

5. SIGNAL STRENGTH: G(Green):GOOD     

A(Amber):MEDIUM   
R(Red):BAD   
OFF

NO LINK 

6. COAX DATA: Coaxial Transmission with High Voltage 
7. PAIRING/RESET: 

PAIRING

 for network group 

join/leave

 / 

RESET 

for factory default network group 

 
CONNECTION DIAGRAM: 

No

ti

ce:    Cable quality, camera bandwidth used and power supply noise can cause actual distances which 

may not match the diagram below.       

 
 

Appli

cati

on Diagram 1:

 

Single Camera EoC with PoE Transmission System

 

 

Appli

cati

on Diagram 2:

 

Single Camera EoC with PoE Transmission System Alternate Power Supply Location 

 

 

Monitor

DC 56V/65W

Max 600m (RG6)

NVR

Switch

”P

Etherne

t Over Coaxial Transce

iver with PoE

Ethernet Over Coaxial Transceiver with PoE

PoE

PoE Camera

”P

Monitor

NVR

Switch

”P

Max 600m (RG6)

Ethernet Over Coaxial Transceiver with PoE

DC 56V/65W

Etherne

t Over Coaxial Transce

iver with PoE

PoE

PoE Camera

”P

Summary of Contents for EOCCPK

Page 1: ...l cable to IP POE cameras Up to 600 Meter transmission distance when using RG6 cable 1640ft using RG59 cable Built in 6KV surge protection at BNC and 4KV at RJ45 ports SPECIFICATIONS MODEL EOCCPK Extender Interface Connector Type 1x BNC Cable Type 75 ohm RG59 RG6 or RG11 video grade coaxial cable Max Transmission Distance 600m 1968ft for RG6 coaxial cable 500m 1640ft for RG59 Ethernet Interface Co...

Page 2: ...e same network group by factory default they can be installed directly with no need for pairing again 2 The transmission system consists of one transceiver at NVR side and one transceiver that connects to IP cameras or other IP devices 3 When using two or more transmission systems at the NVR or Control room if there is no cross talk between the two systems then there is no need to perform the pair...

Page 3: ...oin leave RESET for factory default network group CONNECTION DIAGRAM Notice Cable quality camera bandwidth used and power supply noise can cause actual distances which may not match the diagram below Application Diagram 1 Single Camera EoC with PoE Transmission System Application Diagram 2 Single Camera EoC with PoE Transmission System Alternate Power Supply Location Monitor DC 56V 65W Max 600m RG...

Page 4: ...1 3 seconds the LED color will turn RED and start blinking Step 4 Slave Side Transceiver Leaving Current Network Group On the transceiver at the Remote side close to IP camera device using a straightened paper clip to push the small button for 5 8 seconds the LED color will turn AMBER blink once then turn OFF Step 5 Slave Side Transceiver Joining New Network Group EOC transceivers at Remote side c...

Reviews: