OM3-80 12/21
Lubrication & Maintenance/250 Hour/6 Month (Continued)
Continued on next page
RG19661,00003D4 -19-28FEB13-2/3
may be located on either side of the engine in
a high- or low-mount location.
IMPORTANT: Filtration of oils is critical to
6. Wipe both sealing surfaces of the header (D, E) with a
clean rag. Ensure that the notches in dust seal (F) are
properly installed in the slots of the housing. Replace
if damaged.
used for REMOVAL ONLY.
dust seal (F). DO NOT apply an extra 3/4 to 1-1/4 turn
Oil Pan Drain
Plug With Copper
Washer—Torque............................................................. 70 N·m (52 lb-ft)
Oil Pan Drain Plug With
O-Ring—Torque............................................................. 50 N·m (37 lb-ft)
A—Oil Filter Element
B—Inner Seal
C—Outer Seal
D—Sealing Surface On Header
E—Sealing Surface On Header
F—Dust Seal
RG22045
—UN—29NOV12
Oil Filter
RG
11
61
7—
UN—24OCT0
1
Oil Filter Seals
RG2204
6—
UN—29NOV12
OIl Filter Mounting Header
Northern Lights
RG19661,00003D4 -19-28FEB13-3/3
9. Fill engine crankcase with correct John Deere engine
oil through rocker arm cover opening (A). (See
DIESEL ENGINE OIL in Fuels, Lubricants, and
Coolant Section for determining correct engine oil.)
see ENGINE CRANKCASE OIL FILL QUANTITIES in
IMPORTANT: Immediately after completing any
oil change, crank engine for 30 seconds
without permitting engine to start. This will
help insure adequate lubrication to engine
components before engine starts.
NOTE: Crankcase oil capacity may vary slightly.
10. Start engine and run to check for possible leaks.
11. Stop engine and check oil level after 10 minutes. Oil
level reading should be within crosshatch on dipstick.
A—Rocker Arm Cover Oil Filler
Opening
26
