North FL15, Manual For Use And Maintenance

Page: 4 / 10

4
I NSTRUCTIONS FOR INSTALLATION
1. INSTALLATION PLACE
Install the appliance only in spaces with sufficient
ventilation
2. POSITIONING
•
Remove the appliance from the packing;
remove the protective membrane from the
external panel, being careful do not remain
any of glue. In this case, you remove with the
suitable resolve
•
Place the appliance on metal base
•
Regulate the height of surface of work via the
regulated legs of support.
•
The appliance is not suitable for built-in
installation
•
Do not place the appliance under hot area.
•
Do not close the bottom of the appliance.
ATTENTION.
Do not close the bottom of the machine. Which cool
the control internal components.
3. ELECTRIC CONNECTION
•
The connection in the network of electric
appliance be executed according to the
being in effect regulations
•
Before you realise the connection you are
certified that the tendency and the frequency
correspond in the prices that are entered in
the plate the appliance should it is connected
with way constant in the network of
appliance. The connection should be
executed with cable of type H07RN-F. The
electric cable should be installed with metal
or inflexible plastic pipe. If the connection use
way of an existing lead should not enter in
the interior of appliance and make sure the
tube have no sharp edges.
•
Before the appliance it should be installed
switch of protection with suitable benefit,
distance of opening between the contacts at
least 3 mm. This should switch install itself in
the constant electric installation of building, in
point near in the appliance.
•
The appliance should be connected with the
earthed of network. Finally, the appliance
must also be connected to an equipotent
system. This connection is executed with the
screw of with holding and is found in the
abroad, near in the entry of electric cable.
The equipotent cable should have minimal
cross-section 10 mm2.
3.1 CABLE INSTALLATION
Connect the plug in to the power.