SIP configuration
53
Configuration Guide
End
Variable definitions
The following table describes the variables and values for configuring FXO information.
Variable
Value
FXO Channel
Select the required FXO channel.
Channel Enable
Select this check box to enable the administrative status of the
FXO channel.
The channel is available for use only when it is enabled.
Channel Number
Type the FXO channel number. This is the number which
identifies the FXO line for an incoming call.
Password
Type the password to access the FXO Channel.
Forward Number
Type the forward number. This number is used when an
incoming call on the FXO channel requires forwarding.
Emergency Number
Type the emergency number of the contact.
Ring Count
Type the ring count. This is the maximum number of rings
within which FXO must get an answer from the remote
number.
The minimum value is 1 and maximum value is 6.
The default value is 2. This default appears after you configure
the channel number.
On Hook Detection Time
Type the on-hook detection time.
The value ranges from 100 to10000 milliseconds.
The default value is 2000 milliseconds. This default appears
after you configure the channel number.
Summary of Contents for BSG12aw 1.0
