Nortel BCM50a, Configuration Manual

Page: 91 / 315

Chapter 9 Network Address Translation (NAT) 91
BCM50a Integrated Router Configuration — Advanced
Figure 31 Menu 11.3 – Applying NAT to the Remote Node
Table 17 describes the fields in Figure 31 .
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Dynamic Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 15
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
Table 17 Applying NAT in Menus 4 & 11.3
Field Description Options
Network
Address
Translation
When you select this option the SMT uses Address
Mapping Set 1 (menu 15.1 - “Address Mapping Sets” on
page 92 for further discussion). Choose Full Feature if you
have multiple public WAN IP addresses for your BCM50a
Integrated Router.
When you select
Full Feature you must configure at least
one address mapping set!
Full Feature
NAT is disabled when you select this option. None
When you select this option the SMT uses Address
Mapping Set 255 (menu 15.1 - “Address Mapping Sets” on
page 92 ). Choose SUA Only if you have just one public
WAN IP address for your BCM50a Integrated Router.
SUA Only