QUICK INSTALL GUIDE
8
e.
Installing the ITP-8 Bracket
The ITP-8 includes a mounting bracket that must be used. Using the
included screws, mount the bracket to a standard 2 gang electrical box
or low voltage bracket and verify that the bracket is level before tightening
the screws.
f.
Connecting the ITP-8 to Power
The ITP-8 is designed to be powered over the Ethernet connection (PoE)
or by connecting a 12V DC power supply (not included), but not both.
If both the PoE and a 12V DC power supply are connected the ITP-8 will
draw power from the 12V DC source.
2 Gang Box
PoE Connection
PoE connection requires that IEEE 802.3af standard (13W maximum draw
@48 V DC @270 mA) is met. Use a network switch or PoE injector that meets
this standard.
Connect the ITP-8 using a standard T568A or T568B Ethernet cable from
the network switch to the LAN/PoE jack. If you have terminated your own
CAT 5e/6/7 cable use a tester to ensure that both ends have been properly
terminated.
