Doc No. 700016 Page 9 of 16
The heater assembly is now complete and can now be installed.
We would recommend that the
burner and heat exchanger be assembled once the heater has been installed in the roof space.
Locate 6 off No.5 torque screws. Position the
blank canopy end cap with the end cap flanges
facing
inwards,
beneath the canopy profile at the
U bend end & fix with screws. Repeat procedure
for 'cut-out' canopy end cap, again ensuring the
flange faces
inwards.
2.5.6 Canopy End Caps
16
2x 2x
12x 12x
CAUTION — SHARP EDGES!
17
1x 1x
1x 1x
2.5.7 General
2x
12x
1x
1x
2.6 Detailed Assembly Drawings
The following pages show the technical
dimensional details of the VSX heaters.
Please note the heater type, length and
reference number from the delivery/advice note
before identifying the correct model drawing.
Refer to figure 12 for details of
‘W’, ‘X’, ‘Y’ and
‘Z’
fastening and locations.
