Doc No. 700016 Page 7 of 16
Remove protective film before starting.
Reflectors are supplied pre-punched and
are universal throughout the VSX series.
Starting at the burner end, slide the reflectors
through the brackets until they are all roughly in
position along the heater, referring to the assembly
diagram showing overlaps. Measure the distance
between the end of the burner end tubes & the
centre of the end bracket,
This should be
6” (150mm)
, slide bracket along tubes to adjust,
then tighten U bolts on the end bracket.
2.5.3 Reflectors.
2x 3x
7
CAUTION — SHARP EDGES!
Slide end reflector so that the innermost
slotted holes line up with 1st bracket fixing holes,
then fix in place using M6 x 35mm pins, washers
& nuts.
2x 2x
8
Repeat this procedure referring to the
assembly diagram for quantities used on specific
models, but noting that the final bracket
is not
bolted to the reflector. (See photo)
10
At this stage
all the U bolts should be
fully tightened.
3x
2x
Slide 2nd bracket to line up with innermost
slotted hole in 1st reflector, & bolt together using
M6 x 35mm pins, washers & nuts. Bolt 1st & 2nd
reflectors together using end elongated holes in
each. Refer to notes ‘W’, ‘X’, ‘Y’ and Z in fig.12 for
further details.
9
4x 4x 4x
