40
CR60-IM.v0429.4
Securing Commercial Water Heating System Wall Mount
•
Before mounting the CR60 to the wall, make sure the wall is capable of supporting the fully assembled
weight of the CR60.
•
Consult a structural engineer for appropriate methods or structural analysis before attempting to wall
mount the fully assembled CR60.
•
Failure to comply with the above requirements could result in substantial property damage, personal
injuries or death.
General Instructions for Mounting All CR60 Wall Hanging Racks
•
Identify the installation location and confirm that the installation will meet all required clearances.
•
There are no pre-drilled holes in the CR60 frame. Refer to the below for proper fastening instructions:
1.
Identify fastening points (i.e. stud) at a maximum 18 in. apart.
2.
Drill 5/16” clearance holes through the top frame of the CR60 rack corresponding to each
fastening location
3.
Use ¼” x 2 ½” Wood Lag Bolts along with a ¼” flat washer (Field Suppli
ed)
4.
Tighten lag bolts
Commercial Water Heating System
Wall Mount Models
•
The minimum number of fastening points shall be:
Model
Number of
Fasteners Required
CR60-WH-2
8
CR60-WH-3
12
CR60-WH-2
CR60-WH-3
Summary of Contents for NCC199CDV
