39
CR60-IM.v0429.4
Securing Floor Standing CR60 Models
•
All mechanical components shall be anchored and installed in accordance with national and local codes
including anchorage to building structures.
•
To secure all floor standing models, 7
/16”
diameter holes are pre-drilled in the base rail. Refer to the
figure below for location of these holes.
•
For minimum concrete thickness, refer to local codes or consult with a licensed structural engineer
regarding the use of appropriate expansion anchors capable of supporting the CR60 weight. The fully
assembled weight is available in the specifications section of this manual.
•
For outdoor installations, anchors shall be capable of supporting both the weight of the CR60 as well as
wind shear loads.
Applicable Models
CR60-FS-4
CR60-FS-6
Bottom View: Marked locations for installing floor anchors
CR60-FS-5
Summary of Contents for NCC199CDV
