Noritz N-084M-DV-CA, Owner'S Manual And Installation Manual

Page: 37 / 158

37
3.
Quick Connect Multi System Installation
• The Quick Connect Multi System allows the installation of two units together utilizing only the Quick
Connect Cord.
Typical Plumbing
The Quick Connect Cord is 2m (6ft.) long. Install the two units 470mm (18.5")-950mm (37.4")
apart at the center to ensure the cord will be able to reach between the units. (See Typical
Plumbing diagram). (If the distance between the two units is too great, not only will the cord
not be able to reach,but the water temperature may also become unstable because of the
difference in pipe length between the two units.)
* When connecting 2 devices, use only a
single remote controller.
Note: Connect the remote
controller to only one
of the devices.
System Diagram
• Insulate the hot water piping to prevent heat loss. Insulate and apply heating materials to the cold
water supply piping to prevent heat loss and freezing of pipes when exposed to excessively cold
temperatures.
G
Quick Connect
Cord
Remote Controller Cord
Gas Supply Piping
Cold Water Supply
Hot Water
Remote Controller
Terminal Block
Cord
Connector Cord
Connector
Leave enough clearance around the plumbing
to apply insulation. It will be necessary to add
bends to the piping to ensure that this
clearance is available. Size the piping to allow for the maximum
flow rates of the units.
Union
Distance at center: 470-950mm (18.5-37.4")
Quick Connect
Cord
Pressure
Relief
Valve
Union
Gas Valve
Union
Shutoff
Valve
Shutoff Valve
Hot Water
Shutoff
Valve
Cold Water
Distance on sides
5-483mm
(0.19-19")
Make this distance as short as possible.
* The hot water temperature will
become unstable as the pipe
length increases.
SAR8210̲035̲045̲E̲J.p65
05.11.29, 3:06 PM 37