Noritz N-084M-DV-CA, Owner'S Manual And Installation Manual

Page: 15 / 158

15
An alarm will sound for ten
seconds when the flow
reaches the set level.
The water will continue to run unless it is
manually turned off.
5
Turn off the hot
water when the
alarm sounds.
4
Turn on hot
water.
3
Adjust flow meter
alarm setting.
To set the flow meter alarm:
Press the flow meter alarm set button
(the setting will flash on the display)
and adjust with the setting buttons.
Increase
Decrease
Note:
The alarm will not
sound if it is set for
990L (262gallons).
On
Flow meter setting will be flashing
(ex. 180L (48gallons))
* The level can only be adjusted
while the indicator is flashing.
* After ten seconds, the remote
will again display the temperature.
Off
If the flow meter alarm is being used to indicate when a tub is full:
•
If any hot water is being used besides what is going into the tub, the alarm will sound before
the tub is full.
•
If there was water in the tub before the fill began, or if the water is not shut off manually when
the alarm sounds, the tub may overflow.
•
If there was water in the tub before the fill began, the temperature in the tub after it is full may
be different from the temperature setting.
The alarm will sound when
the set level has been
reached. Stop the water.
Choose the flow meter alarm setting from the
following options: 38 - 260 L (10 - 60 gallons) (In
20 L (5 gallons), 300 L (80 gallons), 340 L (90
gallons), 380 L (100 gallons), 990 L (262 gallons).)
Note:
The alarm will not sound if it
is set for 990L(262gallons).
(
°
C (
°
F):
)
* Initial factory setting: 40
°
C (104
°
F)
Water Temperature
The temperatures settings below are only examples. The
temperature setting necessary will depend on the usage,
the length of piping and the time of year.
37 38 39 40 41 42 43 44 45 46 47 48
(99) (100) (102) (104) (106) (108) (109) (111) (113) (115) (117) (118)
Warmer Hot Warm
SAR8210̲014̲026̲E̲J.p65
05.11.29, 3:05 PM 15