Noritz EZ2FVK-2, Installation Manual, Page: 17 / 24

17
Step Installation Procedure(ex. @Garage) Necessary Tool
16 Insert " ⑧ Rigid 45 Elbow Set" to the equipment's vent connector pipe. When inserting " ⑧ Rigid
45 Elbow Set" , there is tension when it passes through the o-ring within the equipment’s vent
connector pipe. Continue to insert " ⑧ Rigid 45 Elbow Set" until it is firmly seated all the way into
the base of the vent connector pipe.
⑧ Rigid 45
Elbow Set
17 Follow the next [Point] and cut the " ③ Flex Pipe 2"" into appropriate length.
Marker
[Point]
If it interferes with water and hot water piping, adjust " ⑧ Rigid 45 Elbow Set" 's angle so
that it does not interfere. If the contact is unavoidable, take measures such as inserting
heat insulator so that it does not have direct contact.
Step-3
(W
ork where equipment is installed)
At this step, be very careful when cutting the " ③ Flex Pipe 2"". If it is cut too
short, you must dispose of the vent or use it on another installation where a
shorter length is required. These vent pieces cannot be lengthened.
Be sure to do
Do not disassemble
"
⑧
Rigid 45 Elbow Set" to use.
Be sure to do
<Type A> 3"
<Type B> 4
3
/
4
"
PVC Cutter
Box Cutter
or