2.3 Processable films
2 ñ 8
Tape (splicing tape etc.)
is attached to either end
of the film.
If tape is attached to the leading or rear end, cut the end perpendicularly, if there is enough
space. If there is not enough space, remove it without leaving any gum and making film end
wave.
This will prevent a film jam because of the thick and sticky film.
ï For the heat spliced film, cut the spliced part.
ï For the R-cut film, remove the splicing tape.
The check label is
attached to the film.
If you process a film with the check label on it, cut off the unnecessary part. Cut the film 2 mm
or more away from the label attaching position.
Do not cut the check label.
Perforation is damaged.
N
OTE
ï This occurs only to
135-type films.
If a perforation is damaged, cut the broken part perpendicularly, if there is enough space.
If a perforation at any position other than at both ends of the film is damaged, mend the
damaged part using tape. Do not allow the tape to protrude from the film.
Symptom
Corrective action
Check label
2 mm or more from the front end of
film
Summary of Contents for LS-600
