Push button to begin scanning. The LED ring around
the button turns from blue to green or teal (based
on satellite lock) when Stencil Pro scanning has
started. Initiation takes approximately 4-5 seconds.
Starts Scanning
Scan Buttom
Press button to stop scanning. The LED ring
around the button turns from green/teal to yellow
while saving, then returns to a blue ready state.
Stops Scanning
Turn the switch up to power on the controller. To
utilize shore power, connect the controller’s AC
adapter.
Up/On
Turn the switch down to turn off the controller.
Down/O
Push button to begin scanning. The LED ring around
the button turns from blue to green or teal (based on
satellite lock) when Stencil Pro scanning has started.
Initiation takes approximately 4-5 seconds.
Starts Scanning
Scan Button
Power Switch
Press button to stop scanning. The LED ring around
the button turns from green/teal to yellow when
saving, then returns to a blue ready state.
Stops Scanning
Back of Scanner
Scanner Data Connector
Scanner Power Connector
USB-C Port
HDMI Port
USB-A Ports
LED Status Lights
Shore Power Connector
Data Connector
Power Connector
Front of Controller
GNSS Antenna
Antenna Bracket
Velodyne 32-Line
Lidar Sensor
Pano/Color
Camera
Odometry
Camera
5/8-11 Threaded
Base
