Nordson BC5100, Product Manual, Page: 39 / 46

BC5100 Bar Code Scanner
35
Part 1076483A
E 2007 Nordson Corporation
Repair
WARNING:
Allow only personnel with appropriate training and experience
to operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
WARNING:
If this equipment is used with other Nordson equipment, refer
to the manuals provided with that equipment for instructions and applicable
precautions. Failure to observe this warning may result in personal injury or
death.
Replacing a Scanner
CAUTION:
Failure to observe may result in equipment failure.
WARNING:
Do not open the scanner housing when power is applied to the
scanner. Opening the scanner could expose you or others to eye injury from
the laser light. With the housing open, the laser light intensity can reach a
power of 7 mW.
WARNING:
Never look directly into the laser light source or point the beam
at other people. Looking at the source of the laser beam can cause serious
injury to the eyes.
1. Make sure that the LogiComm control system is turned off.
2. Wait five seconds for the power supply voltage to bleed off.
3. Disconnect the scanner interconnect cable from the cordset on the
scanner.
4. Remove the scanner from its mounting and replace it with a new one.
5. Attach the cordset of the new scanner to the interconnect cable.
6. Turn on the LogiComm control system.