Nordson BC5100, Product Manual, Page: 31 / 46

BC5100 Bar Code Scanner
27
Part 1076483A
E 2007 Nordson Corporation
Start the System
1. Make sure that the LogiComm control system is powered on.
2. Start the production line and run it at jog speed.
3. Stop the line when the entire bar code is within the scan line.
4. Start the production line.
5. Press Learn Code on the BC5100 menu screen.
6. Verify that the code is the correct bar code before teaching it to the
system.
7. Press Teach Active Sensors on the Main Menu screen.
8. In the BC5100 menu screen, observe the data in the following counters:
S
Match
S
No Match Defects
S
No Read
NOTE:
If the Match counter has zero defects, go to step 9. If the
No Match Defects counter displays zero (0), repeat the Learn Code
procedure, making sure that the code used to teach the system is
good (and properly designed) and that the product is stationary
during the teach process.
9. Increase the line speed to normal operating speed. Allow the line speed
to stabilize and ensure that the feed system is stable.
NOTE:
Examine the displayed bar code image. Make sure that at least one
product is sensed after the learn product before a new bar code image is
displayed. If the displayed image is very dark, the distance from the sensor
to the product needs to be adjusted. Adjust the distance until the image is
legible.