Electrical connection
x
Your washing machine is set to 220-240V and 50Hz.
x
Mains cord of your washing machine is equipped with a specific
grounded plug. This plug should always be inserted to a grounded
receptacle of 10 amperes. Fuse current value of the power line
connected to this plug should also be 10 amperes. If you don’t
have such a receptacle and fuse confirming with this, please have
it done by a qualified electrician.
x
We do not take the responsibility of the damages that occur
due to ungrounded usage.
x
Operating your machine under low voltage will cause the life cycle
of your machine to be reduced and its performance to be
restricted.
Water inlet connection
x
Your machine may have either a single inlet (cold) or double water
inlets (cold/hot) based on its specifications. White-capped hose
should be connected to cold water inlet and red-capped hose to
hot water inlet (applicable for machines with double water inlets).
x
To eliminate water leakages in points of contact, 1 or 2 nuts are
provided in the hose package (applicable for machines with double
water inlets). Fit these nuts to the ends of new water inlet hoses on
the side of faucet.
x
Connect the white-elbow end of the water inlet hoses to the white-
filtered water inlet valve on the rear side of the machine and the
red-elbow end to red-filtered one (applicable for machines with
double water inlets). Tighten plastic parts of the junctions using
your hand. In uncertain conditions, have the connection works be
done by a qualified plumber.
x
Flow of water with pressure of 0.1-1 Mpa will allow your machine to
operate more efficiently (0.1 Mpa pressure means that more than 8
litres of water will flow through a fully-tapped faucet per one
minute).
x
Ensure that points of contact do not leak by tapping the faucet
completely after carrying making the connections.
x
Ensure that new water inlet hoses are not folded, broken, crushed
or their dimensions are not altered.
x
Mount new water inlet hoses to a ¾ , threaded faucet.
x
If your machine has double hot water inlets, the temperature of hot
water inlet should be maximum 70°C.
10
CHAPTER -3: SETTING UP
ELECTRICAL CONNECTION / WATER INLET CONNECTION
