Nordmann Engineering SPA Display, Installation And Operation Manual

Page: 26 / 36

26
6. Free the shielding of the CAN BUS cable(s) by removing the insulation at the appropriate position.
Then, pinch the freed shielding of the CAN BUS cable(s) into the clamp holder on the right side of
the Condair Delta SPA Control Box or at the bottom in the housing of the Nordmann Omega.
Fig. 24: Feeding the cable(s) through the ferrite ring(s) and fixing the cable shield(s) in the clamp
holder(s)
7. Remount front panel of the Nordmann Omega or Condair Delta SPA Control Box, respectively.
8. Put the Nordmann Omega or Condair Delta SPA Control Box, respectively into operation.
Assumed the cabling is correct the home screen is shown on the Nordmann SPA Display after start-
up of the Nordmann Omega.