26
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
you to calibrate the incline and speed of the treadmill,
restore factory defaults, update the console firmware,
calibrate the screen, view technical information, and
perform a network test.
1. Select the settings mode.
See step 1 on page 24.
2. Select the maintenance mode.
Touch the Maintenance
button in the lower right
corner of the screen to
enter the maintenance
mode.
The maintenance mode
main screen will show
information about the
model and version of
the treadmill. If the con-
sole is connected to the
controller of the tread-
mill, the controller dot will be green; if it is not, the
dot will flash. If the treadmill is connected to your
wireless network, the network dot will be green; if it
is not, the dot will be black.
3. Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. The treadmill
will automatically rise to the maximum incline level,
lower to the minimum incline level, and then return
to the starting position. This will recalibrate the in-
cline system. Touch the Begin button to calibrate
the incline system or the Cancel button to return to
the maintenance mode. When the incline system is
calibrated, touch the Finish button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline system
is calibrating. In an emergency, pull the key
from the console to stop the incline calibration.
4. Calibrate the speed of the treadmill.
Stand on the foot rails or stand on the floor.
Touch the Calibrate Speed button and then touch
the Begin button. The walking belt will begin to
move. When the walking belt stops moving, touch
the Finish button. Touch the Cancel button to re-
turn to the maintenance mode. Note: This feature
may not be enabled.
5. Restore factory defaults.
If necessary, touch the Restore Defaults button to
reset the firmware to the original factory firmware.
This will erase all firmware updates that you have
downloaded. Touch the Begin button to restore the
default firmware or the Cancel button to return to
the maintenance mode.
To avoid damaging the
treadmill, do not turn off the power or remove
the key while the factory defaults are being re-
stored.
When the restoration is complete, the treadmill will
turn off and then turn back on. If it does not, press
the power switch into the off position. Wait for sev-
eral seconds, and then press the power switch into
the reset position. It may take a few minutes for the
console to be ready for use.
