27
6. Update the console firmware.
For the best results, regularly check for
firmware updates.
Touch the Firmware Update button. Touch the
WiFi button to check for firmware updates using
your wireless network. Touch the Begin button to
check for updates or the Cancel button to return to
the maintenance mode.
If you cannot update the console firmware over
your wireless network, you can update the
firmware using a USB drive. Touch the USB button
to install firmware updates using a USB drive. Go
to www.iFit.com and download the firmware update
onto your USB drive. Safely remove the USB drive
from your computer and plug it into the USB port
on the side of the console. Press the Begin button
on the screen or press the Cancel button to return
to the maintenance mode.
To avoid damaging the treadmill, do not turn
off the power or remove the key while the
firmware is being updated.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position. Wait for several
seconds, and then press the power switch into the
reset position. It may take a few minutes for the
console to be ready for use.
7. Calibrate the screen.
If the screen is not properly calibrated, it will be dif-
ficult to touch the correct buttons on the screen. To
calibrate the screen, touch the Calibrate Screen
button and then touch the Begin button. Touch the
Cancel button to return to the maintenance mode.
A small target will appear on the screen.
Using a pencil eraser or other small object, touch
the center of the target. Then, touch the rest of the
targets. After several seconds, the console will exit
the calibration mode.
Note: If it is difficult to press the buttons while using
the Internet browser, the browser screen should be
calibrated. Press and hold the menu button on the
console until a + appears on the screen. Using a
pencil eraser or other small object, touch and hold
the center of the + for a second. Then, touch and
hold the rest of the targets. After a few seconds,
the console will exit the calibration mode.
8. View technical information.
Touch the Technical Info button to view the total
number of hours that the treadmill has been used
and the total number of miles that the walking belt
has moved. After you view the information, touch
the Finish button.
9. Perform a network test.
Touch the Network Test button to check the con-
nection status of the treadmill. The wireless inter-
face status shows whether the wireless feature on
the treadmill is turned on or turned off. The network
access status shows whether the treadmill can
connect to your wireless network. The DNS service
status shows whether the treadmill can communi-
cate with the DNS server. The iFit.com status
shows whether the treadmill can communicate with
iFit.com. If all the connections are successful, the
console will display the word SUCCESS.
10. Exit the maintenance mode.
To exit the maintenance mode, touch the home
button on the screen repeatedly.
