7
3. Attach the Latch Housing (89) to the Left Upright (90)
with two Latch Bolts (77).
Do not overtighten the Latch
Bolts.
3
90
89
77
95
108
86
86
88
99
90
2. Slide the Right Upright (95) fully onto the bracket on the
Base (99).
Be careful to avoid pinching your hands or
the Upright Wire Harness (108).
Using your fingers, tighten four Upright Bolts (86) and two
3/8" Star Washers (88) into the Right Upright (95) as
shown. If necessary, adjust the position of the Right
Upright to align the Upright Bolts with the holes.
Do not
fully tighten the Upright Bolts yet.
Attach the Left
Upright (90) in the same way. Note: There are no wires on
the left side.
2
4. Remove the elastic band holding the Upright Wire
Harness (108). Have two people hold the console as-
sembly near the Left Upright (90) and the Right Upright
(95). Connect the Upright Wire Harness to the Console
Wire Harness (61).
See the inset drawing. The con-
nectors should slide together easily and snap into
place.
If they do not, turn one connector and try again to
connect them.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Insert the Wire Harnesses (61, 108) into the Right
Upright (95). Next, insert the front ends of the brackets
on the console assembly into the Right Upright and the
Left Upright (90). Then, insert the rest of the brackets
into the Uprights.
Make sure that the Wire Harnesses
are not pinched.
95
Console
Assembly
Front of Bracket
90
61
108
4
108