5
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the
included hex keys, assembly requires a Phillips screwdriver
, an adjustable
wrench
, and a rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly.
Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M10 x 19mm Patch
Screw (61)–14
M8 x 45mm Button
Bolt (70)–4
M8 Nylon
Locknut (63)–4
23mm x 19mm
Wave Washer
(76)–4
M10 Split
Washer (79)–10
M8 Split
Washer (80)–8
M10 Washer
(64)–4
M6 x 13mm
Patch Screw
(78)–8
M8 x 13mm
Patch Screw
(62)–8
M4 x 30mm
Screw (74)–4
M4 x 16mm
Screw (67)–9
M8 x 25mm Flat
Patch Screw
(68)–6
M6 x 32mm Patch
Screw (96)–4
M4 x 16mm
Round Head
Screw (95)–4
Summary of Contents for A.C.T. NTCW90907.1
Page 23: ...23 NOTES...
