8
NORDIC
REPLACE THE METAL BLADE TO SPOOL
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped or missing. Replace a
damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and installing a blade.
METAL BLADE:
Turn the tool upside down so that you can replace the cutter blade easily.
To dismount the cutter blade, insert the hex wrench through the hole on the protector cover and receive
washer. rotate the receive washer until it is locked with the hex wrench. Loosen the hex nut (left-hand
thread)with the hex socket wrench and remove the nut, cup, clamp washer and hex wrench.
Mount the cutter blade onto the shaft so that the guide of the receive washer fits in the arbor hole in
the cutter blade . Install the clamp washer, cup, and secure the cutter blade with the hex nut with 13 to
23Nm of tightening torque during holding the receive washer with hex wrench. Then tighten the one nut
by clockwise rotate.
SPOOL:
• Hold the trimmer head, insert the hex wrench through the hole on the receive washer, then tighten the one nut by
clockwise rotate.
• Fit the spring into the trimmer head
• Align the protrusion on the underside of the cover with the slots of the eyelets. Then push cover firmly onto the
housing to secure it. Make sure the latches fully spread in the cover.
If the line is too long when you use the equipment for the first time, the surplus end of it will be cut by
the blade on the guard hood.
OPERATION
BATTERY CHARGER (SOLD SEPARATELY)
The lithium-ion battery can be charged at any time and will not develop a “memory” when charged after
only a partial discharge. It is not necessary to run down the battery pack charge before recharging. Remove
the battery pack from the tool when convenient for you and your job. You can “top-off” your battery pack’s
charge before starting a big job or long period of use.
Due to lithium-ion’s fade-free properties, the only time it is necessary to charge the lithium-ion battery
pack is when the pack has reached the end of its charge. To signal the end of charge, power to the tool will
drop quickly. Charge the battery pack as needed.
