w w w . h a w k e y e e l e c t r o n i c s . c o m
The maximum Keel Offset setting is 20 FT (6.1 M), and can be set in .1
(1/10th)
Feet or Meter increments. The unit will read “---” when a negative value occurs
due to the Keel Offset subtraction.
To set the Keel Offset:
1. Press and hold the "UP" and “DOWN” keys
until the
K/O
indicator begins to blink.
(approximately 6 seconds)
.
2. Release the Keys.
3. Press the "UP” key to increase the Keel Offset
value. Press the "DOWN" key to reduce the
value.
4. The display will return to the normal operation
mode after five seconds if no keys are pressed.
5. “K/O” will remain illuminated in the top left hand
corner indicating that the depth readings are
adjusted to the Keel Offset setting.
UNITS OF MEASURE
The units of measure for the depth readout and alarm functions can be set in 4
easy steps. The two settings available are Feet (FT) and Meters (M). You must
be in the “Depth Sounder” mode to adjust this setting.
To Set the Units of Measure:
1. Press and hold the "UP" and “DOWN” keys
until the current unit of measure begins to blink.
(approximately 8 seconds)
.
2. Release the Keys.
3. To set the units to FEET press the “UP” key.
“FT” will flash on the Display.
4. To set the units to METERS press the “DOWN”
key. “M” will flash on the Display.
5. The display will return to the normal operation mode automatically after five
seconds.
IMPORTANT:
Install and test the display in the desired
mounting location before attempting the
transducer installation.
