norbar EvoTorque ET-119-6000-110, Original Instructions Manual

Page: 7 / 29

5
SAFETY – EVOTORQUE
®
SPECIFIC SAFETY WARNING
This tool is intended for use with threaded fasteners.
WARNING: IF NOT USED PROPERLY THIS PRODUCT CAN BE DANGEROUS!
THIS PRODUCT CAN CAUSE SERIOUS INJURY TO THE OPERATOR AND
OTHERS, THE WARNINGS AND SAFETY INSTRUCTIONS MUST BE
FOLLOWED TO ENSURE REASONABLE SAFETY AND EFFICIENCY IN
USING THIS PRODUCT. THE OPERATOR IS RESPONSIBLE FOR
FOLLOWING THE WARNING AND SAFETY INSTRUCTIONS IN THIS
MANUAL AND ON THE PRODUCT.
 Understand the operation of both the TORQUE mode and the ANGLE mode, especially when applied to
pre-tightened fasteners. Incorrect tool use can easily apply excessive torque.
 Do not block cooling air entry and exit points.
 Do not pull the mains cable to disconnect from AC outlet, grasp the plug.
 Store tool in carry case after use.
 Isolate the tool from all energy sources before changing or adjusting the drive square socket.
 Always use impact or high quality sockets.
 Use only sockets and adaptors which are in good condition.
 Use only sockets and adaptors which are intended for use with power tools.
 Always operate with a reaction bar that is free to move. Do not fix reaction bar to reaction point.
 For very low torque rate joints (e.g. heat exchangers with long rundown threads) the tool will get warm.
In extreme cases the tool safety temperature control will stop the tool.
 It is recommended that Portable Appliance Testing (PAT Testing), officially known as “In-Service
Inspection & Testing of Electrical Equipment” is completed at regular intervals, see MAINTENANCE
section for more information
Markings on Tool
Pictograms on Tool Meaning
WARNING: LIVE PARTS INSIDE. DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE.
Unexpected tool movement due to reaction forces or breakage of drive square or
reaction bar may cause injuries.
There is a risk of crushing between the reaction bar and work piece.
Keep hands away from reaction bar.
Keep hand away from tool output.
Read and understand Operator’s Manual.
EvoTorque
®
Tools without a Reaction Bar
Upon customer request some EvoTorque
®
tools are supplied without a reaction bar. These tools MUST NOT
be used until a suitable reaction bar has been fitted. Norbar define the reaction bar as ‘interchangeable
equipment’ under the European directive 2006/42/EC on Machinery Safety. If applicable a new reaction bar
will need to comply with this directive.