norbar EvoTorque ET-119-6000-110, Original Instructions Manual

Page: 21 / 29

19
9. Joint complete. See lights on display & front of tool for pass / fail status.
If in Angle mode the angle achieved is shown.
FIGURE 26 – Successful joint. Tick and green led shown.
LED Status Meaning Delay To Next Run Action
Fastener tightened to specification. 2 seconds None
X
Fastener NOT tightened to specification. 2 seconds Release fastener and re-tighten
10. Remove the tool from the fastener.
TIP: When tightening multiple fasteners on a flange it is recommended to mark each fastener
when tight.
This is even more important when using the TORQUE & ANGLE mode as applying additional
angle to a tightened fastener will increase the risk of operator danger, fastener damage and
flange damage.
Releasing
1. Fit the EvoTorque
®
with the correct size impact or high quality socket to suit the fastener to be released.
TIP: For added safety it is recommended to secure the socket to the drive square.
This is often achieved using a pin and O ring, see socket manufacturer for guidance.
2. Ensure the clockwise/counter-clockwise display arrow is correct.
Press to set direction.
3. Rotate the handle into a convenient position relative to the reaction bar.
Fit the tool onto the fastener to be released with the reaction bar
adjacent to the reaction point. See figure 27.
4. Adopt a posture to counteract normal or unexpected
movement of the tool due to reaction forces.
5. Press and release trigger to slowly bring reaction bar into
contact with the reaction point.
6. Fully press the trigger and keep fully pressed until the
threaded fastener releases.
TIP: If unable to release the fastener, increase the target torque.
The tool will automatically limit itself to the maximum tool output torque.
Settings
X
RUN 720 °
FIGURE 27 – Anti-Clockwise Operation