6505 Gayhart Street, Commerce, CA 90040
TEL 323.767.2600 | www.noralighting.com | e-mail: [email protected]
© 2021 Nora Lighting, Inc. All rights reserved. Instructions subject to change without notice.
Installation Instructions
NUTP13 Series
120V Continuous IP65 Rated LED Tape Light
032321P2-3
IS-NUTP13-R04
READ PRIOR TO ATTEMPTING INSTALLATION
ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION
INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN
1. Make sure power is off
2. Connect cord and plug into receptacle (Note: When used outdoors, connect to GFCI outlet)
3. Turn power back on.
1. Do not unplug by pulling on cord. Grasp plug and remove from the receptacle or other outlet device.
2. Slide to open fuse cover and remove fuse carefully.
3. Warning: Risk of fire! Replace fuse only with 8 Amp, 125V fuse (included)
4. Close fuse cover
5. Warning: Risk of fire! Do not replace attachment plug. Contains a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
CORD AND PLUG INSTALLATION
FUSE REPLACEMENT
Cord and Plug
Neutral
Line
Note:
Luminaire has a polarized plug (wider pin for neutral and other for line) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not use an extension cord unless plug can be fully inserted. Do not alter or replace the plug.
Slide open to
access fuse
Replacement Fuse
1. Make sure power is off
2. Pull luminaire’s hardwire cable to junction box and connect to supply wires according to NEC code
3. Turn power back on.
HARDWIRE INSTALLATION
Hardwire Cable
BENDING
WARNING:
Single bend of 90° shall not exceed the minimum inside radius of 2" (50mm) as specified in the figure below..
WARNING:
Do not bend on horizontal plane
WRONG
WRONG
CORRECT
MINIMUM INSIDE BEND RADIUS = 2"
