5
NookBox
Installation Guide
IR Pet Detector
Battery
IR-29 Series Detector Motions sensor uses with alkaline or lithium batteries as power source:
• The alkaline-powered models use two alkaline AA 1.5 V batteries as its power source.
• The lithium-powered models use one 3V 2/3A (EL123AP) Lithium battery as its power source.
The Detector features low battery detection function. If low battery voltage is detected, a low battery signal will be sent to the Control Panel
along with regular signal transmissions for the Control Panel to display the status accordingly. For each installation, the battery is installed in
by the factory before shipment with an Insulator inserted.
<NOTE>
When changing batteries, after removing the old batteries, press the Tamper Switch twice to fully discharge before inserting new batteries.
Getting Started
• Pull out the battery insulator to activate battery.
• The LED indicator will flash for 30 seconds. (The Detector is warming up). During the warm up period, the Detector will not be activated.
It is recommended that you stay away from the detection area during this time. After the warm up period is over, the LED will
turn off and the Detector will be ready for operation.
• Put the Control Panel into learning mode, refer to Control Panel manual for detail.
• Press the test button on the front cover.
• Refer to Control Panel manual to complete the learn-in process.
• After the Detector is learnt-in, put the Control Panel into “Walk Test” mode, hold the Detector in the desired location, and press the Test
button
to confirm this location is within signal range of the Control Panel, refer to Control Panel manual to complete Walk Test.
• When you are satisfied that the Detector work in the chosen location, you can proceed to mounting.
