7
NookBox
Installation Guide
Siren Outdoor
Installation
Proceed to installation after complete learning.
Step 1: Disable the Siren Tamper function on the Control Panel (please refer to the Control Panel
instruction manual). The siren will sound a beep to indicate the tamper switch is now
disabled.
<NOTE>
The function Siren Tamper will only turn OFF for a duration of one hour. The Control Panel will automatically
turn the function back ON after the duration.
Step 2: Find the location where the Bellbox is to be mounted.
Step 3: Remove the Top cover by releasing the bottom screw using a Philips screwdriver and remove
the top cover.
Step 4: Hold the Bellbox at the position where it will be mounted, supply power to Bellbox.
Step 5: Check whether BX has a strong enough signal with the Control Panel by putting the Control Panel into Walk Test mode
(please refer to Control Panel manual). Press the Learn Button check whether the signal is strong enough (please refer to
Control Panel manual for signal strength).
Step 6: If you are satisfied with the signal strength, Identify the 3 mounting holes, mount and fix the Bellbox on the wall using the large
screws and wall plugs provided. Secure the screws using a Philips screwdriver. Make sure the Tamper Switch is fully depressed
against the wall.
<NOTE>
The tamper switch protrudes through the back of the unit. When the siren is pulled off from the wall, the alarm will be activated.
Ensure it is fully depressed when the siren is mounted. If there is a gap, pack with suitable spacing material.
Step 7: Replace the Top cover and tighten the bottom screw using a Philips screwdriver.
Step 8: Enable Siren Tamper function in the Control Panel (Please refer to the Control Panel instruction manual).
Step 9: Check if the installation is successful by testing from the Control Panel by arming and disarming function.
Successful arming/disarming is indicated by the table provided in Audio & Visual Status Indication.
<NOTE>
If 5 short-beeps are noticed while arming/disarming, it means the tamper is not fully depressed. Check to ensure that tamper is properly set and then
test from Control Panel again.
Step 10: The installation is now completed.
