6
Step 3. Water Fill
After the humidifier is positioned where it
will be operating you are ready to fill the
humidifier. The bottle lifts straight up and
away from the base. Take care not to
bump or damage fill valve assembly on
the bottom of the bottle.
Remove the side fill cap and fill with
water. Replace cap and twist by hand
until secure. Hold the bottle upright over
the sink. Press up on the valve plunger
for one second to release a small amount
of water. If you hear air bubbles or see
leaks around the side fill cap or Spring
Valve Assembly, retighten and recheck.
WARNING:
To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area.
If controls get wet, let them dry
completely and have unit checked by
authorized service personnel before
plugging in.
CAUTION:
Use only EPA Registered
Bacteriostat. Under no circumstances
should you use water treatment
products designed for Roto belt or
Ultrasonic humidifiers.
Place the water bottle back into the
humidifier base. When positioned
properly, the plunger will open and the
water will flow into the base. The base
will hold the entire contents of the water
bottle. Once the bottle is empty, remove it
and repeat the filling process. The
humidifier is now filled to capacity. To
benefit from less frequent filling let the
humidifier exhaust both the water from
the bottle and the base before filling.
Bottle
Base
HIGH
MEDIUM
ULTRA Q
UIET
REFILL
AUTO
Turn Counterclockwise to
Remove Side Fill Cap
Spring Valve
Assembly
SP6616 NOMA HUMIDIFIER 8/4/05 11:48 AM Page 6
