Ground Balance
Raise the search coil 40cm above the
ground and press the “- / +” key on the
keypad for an estimated number of times
to eliminate the effect. Because the effect
is in the positive direction in the example
below, you should press the “+” key. If the
incoming effect was negative, then you
would press the “-“ key.
Now press the «RESET» button, release
and lower the search coil to 10cm above
the ground again.
You see that the effect coming from the ground is less now. Repeat these steps until you
receive no effect from the ground. When the effect is completely eliminated, save the
ground setting by pressing the “OK” button.
When finished, do not forget to save the ground balance setting by pressing the “OK”
button. When you press the “OK” key, the system will switch to the general detection mode.
If you do not press the “OK” button, the system will not switch to another screen until you
press the “OK” button.
RESET BUTTON:
The reset button will bring all the detection settings of
your system to the settings when you made the ground
balance. Reset should not be used when you are on the
target signal. Otherwise, it may cause loss of depth and
misinterpretation of the signal.
The reset operation should be performed when the coil is away from the target. You are
recommended to reset after each operation.
Note:
When ground balance cannot be performed completely due to high levels of minerals,
return to the “SENSITIVITY” menu and reduce the sensitivity level. Continue this operation
until you can do the ground balance completely.
Note:
Ground balance should be performed on a ground where there is no metal or cavity.
Otherwise, the equipment will detect that you are on a metal or cavity and will warn you
accordingly. In such a case, change your location and do it again.
Summary of Contents for Golden King
Page 1: ...USER MANUAL ...
