NHM–7
Troubleshooting Instructions
PAMS Technical Documentation
Page 34
Issue 1 10/2001
Nokia Corporation
Synthesizer
General instructions
Connect test jig to computer with DAU–9S cable or to FPS–8 Flash Prom-
mer with XCS–4 modular cable.
Make sure that you have PKD–1 dongle connected to computers parallel
port.
Connect DC power supply or FPS–8 to module test jig with FLC–2 cable.
Set the DC supply voltage to 3.9V and set the jumper connector on test
jig to ”bypass” position.
Set the phone module to test jig and start Phoenix service sofware.
Initialize connection to phone. (use FBUS driver when using DAU–9S and
COMBOX driver when using FPS–8)
Select product from the menu: File –> Choose product –>NHM–7
From toolbar set operating mode to ”Local”.
Activate RF controls window from the menu:
Maintenance –> Tuning –> RF Controls
From the RF controls window:
– Select band ”GSM900” or ”GSM 1800” (Default = ”GSM900”)
– Set Active unit to ”Rx” (Default = ”Rx”)
– Set Operation mode to ”Continuous” (Default = ”Burst”)
– Set Rx/Tx channel to 37 on GSM900 band or 700 on GSM1800 band
(Defaults)
Summary of Contents for NHM-7 series
Page 212: ......
