Interface
e pitch of oscillator A can be controlled by the 1v/8va input and offset by
it’s coarse and ne knobs. e pitch inputs are cross normaled.
Pitch B
e pitch of oscillator B can be controlled by the 1v/8va input and offset by
it’s coarse and ne knobs. e pitch inputs are cross normaled.
Pitch A
is a tone control. Consult the following pages detailing each mode to nd the
behavior of this knob in the speci c mode.
Damp
is a tone control. In all modes it controls phase modulation between the two
pitch oscillators.
Fold
Algorithm
Sync will reset the state of the oscillators on a rising edge. Used for sync
modulation. is jack was added starting at serial 700.
Out
Mod
is a tone control. In all modes it controls the waveform of the oscillator
continually varying between sin, triangle and saw.
is a tone control. In all modes it controls the threshold of the wavefolding.
Morph
selects which algorithm is used. ese are detailed on the following pages.
Master
Sync
Out is the AC coupled audio output.
Voltages
controls the sync of the oscillators. When in the middle position both
oscillators are free running. When A is selected oscillator B will sync to
oscillator A. when B is selected A will sync to B.
e CV inputs respond to 0-5v, except for pitch, which responds to 0-8v. e
Sync input responds to a rising edge of around 2v.
3
Noise Engineering
Loquelic Iteritas
Complex Digital Oscilator
