LED Indicator
The security system’s status is reported to you via the LED indicator located
inside the vehicle. The following is a menu of different indications:
Flashing
Armed
Off
Disarmed
On Constant
Valet mode
Rapid Flashing
30-second Passive Arming Countdown
Security System Zone Intrusion Memory
If the security system is triggered during your absence, the siren (horn) will chirp
4 times upon disarming. The LED indicator will flash two to six times to indicate
which zone has triggered the security system.
2 Flashes
Door Zone
3 Flashes
JTI true dual™ impact sensor full impact triggered
4 Flashes
JTI true dual™ impact sensor pre-warn impact triggered
5 Flashes
Trunk/hood zone triggered
6 Flashes
Ignition zone
OPTIONAL FEATURES
Remote keyless entry
The security system can be interfaced with your vehicle’s power door locks. This
feature will lock the vehicle’s doors when the system is armed. It will also unlock
the doors when the system is disarmed. The remote keyless entry feature will
operate even when the system is in the valet mode to always provide the owner
with convenience.
NOTE
: Some vehicles may require additional parts to utilize the keyless entry
feature.
Ignition controlled power door locks
When the ignition controlled power door lock feature is installed, the vehicles
doors can lock automatically when the vehicle’s ignition is turned on and unlock
automatically when the ignition is turned off. The lock and unlock function can be
programmed independently by your authorized JTI installer/dealer.
the security system is in valet mode. At the time of installation, the system
will be programmed to enter valet mode with the valet switch in one of the
following ways:
Factory Default Method:
To place the security system in valet mode, turn the
ignition key to the ON position and press and hold the push-button valet switch
for five seconds. The red LED indicator will turn on solid. The ignition may be
turned off and the security system will stay in valet mode. To turn the valet mode
off, repeat the process and the LED indicator will turn off.
High Security Method:
To place the security system in valet mode, turn the
ignition key to the ON position and press the push-button valet switch five times.
The red LED indicator will turn on solid. The ignition may be turned off and the
security system will stay in valet mode. To turn the valet mode off, repeat the
process and the LED indicator will turn off.
Valet Mode Via Remote
You can also place the security system into valet mode via the remote control by
pressing
and
simultaneously for three seconds. The parking lights will
flash once and the red LED indicator will turn on solid. To turn the valet mode
off, simply repeat the process. The parking lights will flash two times and LED
indicator will turn off.
Panic Feature
You may also trigger the security system via the remote control by pressing
for three seconds. This is done to attract attention to your vehicle.
The siren (horn) will sound for thirty seconds. This feature will also work when
the security system is in valet mode. Pressing
on the remote control will
turn the panic feature off.
Car Finder
Car finder can be used to locate your vehicle in a crowded parking lot. Simply
press
on the remote control two consecutive times to activate car finder.
The siren will sound three short blasts and flash the parking lights. To re-activate
car finder, simply repeat the process.
Multi-Car Remote Operation
Your remote control transmitter is also able to operate a second vehicle if that
vehicle is equipped with a Nobody Messes With..It security system with Elusive
Code™. Your authorized JTI dealer can program this feature.
Vehicle #1 will be the primary vehicle (all functions will operate).
Vehicle #2 will be the secondary vehicle (
on the remote control will
arm/disarm the security system, no other functions will be available from the
primary remote on the secondary vehicle).
4
5
